• Wide bands of rubber
  Provides greater contact area to floor than heel grounders
• Two megohm resistor
  Complies with UL & OSHA standards at all times
• Exceptionally tear resistant dual layer rubber with inner scrim
  Provides long life- saving money
• Non-marring interior
  Will not mar shoes
• Hook and loop fastening system
  Allow for flex during walking; easy to install and remove
• 30" long 8 strand nylon polyester grounding tab
  Does not particulate; superior body to ground contact
• Makes contact at the ball of the foot
  Provides rapid and complete static dissipation; constant contact through entire walking motion
• Made in America
  

Per ESD SP9.2 APPENDIX B - Foot Grounder Usage Guidance “Compliance verification should be performed prior to each use (daily, shift change, etc.). The accumulation of insulative materials may increase the foot grounder system resistance. If foot grounders are worn outside the ESD protected area testing for functionality before reentry to the ESD protected area should be considered.”

Per ANSI/ESD S20.20 Paragraph 6.2.2.2 Personnel Grounding Guidance, “ESD protective flooring, used with approved footwear, may be used as an alternative to the wrist strap system for standing operations.”

ESD Handbook TR 20.20 paragraph 5.2.3 “If the contact area between the bottom of the foot and the floor is not continuous, charge generation may occur especially when a person is walking. Heel straps must be worn on both feet to minimize the amount of time that the body of the person is isolated from ground while walking.”

Suitable for ESD footwear component in Flooring - Footwear System personnel grounding method (<3.5 x 10⁷ ohms per ESD STM 97.1).
Suitable for ESD footwear component in flooring - Footwear System personnel grounding method (<100 volts per ESD STM 97.2).