• True 100% Continuous Monitoring Single Station Continuous Monitor for Operator, ESD Work Surface, and Electrical Ground.
  Continuously monitors the integrity of operator’s electrical ground as well as one operator and ESD workstation, eliminating the need for periodic testing and recording.
• Wave Distortion Technology Provides Real-Time Continuous Monitoring for Operator Path to Ground and Presence of 1 Meg Resistor
  True continuous monitoring (versus pulsed or intermittent) of wrist strap functionality and operator safety according to accepted industry standards.
• Park Snap Feature
  Provides means for operator to disconnect wrist strap cord when normally leaving the workstation without audible (false) alarm sounding.
• Work Surface Monitoring May Be Disabled (NEW)
  Flexibility for work areas where an ESD work surface is not used such as the operator of an SMT machine or oven.
• Full Time Dual Status LEDs (NEW) and Audible Alarm for Operator and Workstation Monitoring.
  Audible and LED visual alarms activate instantly when a failure occurs, alerting user and supervisor of problem, allowing immediate corrective action.
• Miniscule Electrical Current Required to Generate Waveform Monitoring Signal
  Safe to use with sensitive components and no reported case of skin irritation
• Easy to Install Housing with Screws or Adhesive Backed Velcro® Strips
  Optional mounting suitable to most machinery and work area, even in hard to reach locations
• Calibration Unit Available for Accurate Performance And Conformity Testing In The Field (See Desco Item 98220 Click Here)
• Made in America

Note: Continuous Monitors pay for themselves improving quality, productivity, eliminating wrist strap daily testing and test result logging. Per ESD-S1.1 paragraph 6.1.3 Frequency of Functional Testing "The wrist strap system should be tested daily to ensure proper electrical value. Daily testing may be omitted if constant monitoring is used."

Per ESD Handbook TR 20.20 paragraph 5.3.2.4.4 "Typical test programs recommend that wrist straps that are used daily should be tested daily. However, if the products that are being produced are of such value that knowledge of a continuous, reliable ground is needed, and then continuous monitoring should be considered or even required."

Note: Work surface must have a conductive layer such as Dual Layer Rubber or Dissipative 3-Layer Vinyl or Micastat® Dissipative Laminate with conductive buried layers. Our Continuous Monitors are not recommended for use with homogeneous matting